D M C
|Model:||UNISAND K 1350|
WIDE BELT (50" - 90", 4-HEAD)
|Year of Mfg.:||2005|
|Condition:||Very good condition|
|Elect./Voltage:||460 V, 60 Cy, 3 Ph.|
|Value New:||$ 160,000|
|Price:||$ 47,250 USD||(Convert)|
|Financing:||$ 961 National Capital Leasing|
|Region:||WEST COAST (Click for Regional Map)|
DMC UNISAND K-1350 Wide Belt Sander, (4) Heads
53" Width cap. Drum, Drum, Orbital, Orbital Head
1st Head: Contact Drum
Belt Back Roll D = 165mm
Work Width = 1350mm
Electrical Components 460 V 60hz
Group Roller Calibrating / Sanding
Roll Diameter 320 Mm.
Roller Rubber 85 Shore
On / Off Air Roll
Engine 26 kW (35 HP)
2nd Head: Contact Drum
Automatic Positioning Units
Group Roller Gauge / Sanding
Oscillating Blower For Tape Cleaning
Bush Blower For Cleaning Tape
Roll R-Cl Diameter 320 Mm.
Roller Cal / Sanding Rubber 65 Shore
On / Off Air Roll
Engine 22 kW (30 HP)
3rd & 4th Head: Orbital Heads
Group Superfinisher Orbital Pad "Fs / Po"
Intermediate Blowers Between Two Groups Orbital
Fifth Group Orbital Pad "Fs / Po"
Machine With Group Orbital
Double Blower Intermediate Orbital
Double Entry Roller
Hardness 50 Shore Conveyor Belt
Measure Unit In Inches; Electronic Positioning Of Working units
Connection Master-Slave Control Hydra
Busy Machine Photoelectric Sensor
Feed Belt Motor With Inverter 5.5 kW
Equipped with and Features:
Ferrari Vacuum Blower Hold down for feed belt
Automatic Regulating Flow Valve
Muffler For Depressor
Double Auction Blowers For Pieces Cleaning
Electronic "Inch" thickness readout device for the working thickness positioning without the need for direct mechanical contact.
Electronic device is equipped with a decimal regulator system to set the bed higher or lower than the thickness of the workpiece.
Operator & Machine Controls:
Hydra V-Pad PLC Control panel with: a 5.7" LCD Color Touch-Screen display, manual settings or memory storage for up to (120) individual working programs.
Hydra V-Pad PLC Control offers complete management of EPICS electronic sectional pads on infeed & outfeed sections of the workpiece, management.
Dims & weight: Machine is approx. 12,000 Lbs, 96 w x 120 L x 96 H
Separate vacuum 24 x 24 x 72 inches
Needs a rigger to load
NOTE: Some spec's need to be verified. The actual Model number is USK-1350M4. This is not a constant pass line sander
|Special Note:||Rare Find|
|Comment:||This is a rare find and very well priced!|
|Written By:||Joe Retzlaff|
|*Dimensions:||120" L x 96" W x 96" H|
*Dimensions & Weight data are based on 3rd party information and could be incorrect; please verify & confirm if accurate dimensions & weight are required.