For Immediate Help Contact:
Dale Granger
(800) 374-5009 ext. 331
Intl. +1 (704) 841-2001
If not available, try his/her backup:
Ed Webb ext.377


Model:   BTA
Machine Type:  


Year of Mfg.:   1980
Condition:   Good Condition   
Value New:   Please call
Price:   Please call     (Convert)
Region:   MIDWEST (Click for Regional Map)
EXF #:   DQ-010155  
Description:   (view full)

Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine


  Number of Spindles:  1

  Chuck:  15.5” 3-Jaw  

  Swing Over Ways :  20”  

  Through Hole:  5.25”  

  Drilling Diameter Max:  4”  

   Drilling Depth Max:  126”  

  Feed Rate:   .5 to 12 IPM  

  Main Motor:   40 HP

  High Pressure Coolant Pump:   10 HP

  Electrics:  480V / 60Cy / 3 P  

  Machine Dimensions (approx):   17’ x 4’ x 6’8”  

  Coolant System Dimensions (approx):   11’ x 8'4" x 8’   

Equipped with:

  Enerpac Hydraulic Clamping System

  Chip Box

  Whip Guide

  Pressure Head

  Rack & Pinion Handwheel for Set-Up Positioning

  Manual and Automatic Operation Controls

  Manual Operation Controls for Spindle Run

  Rapid Advance

  Forward Feed, Retract, E-Stop, and Emergency Retract

The Drill is Currently Set-Up on a 15’ Base. The 40 HP Drill Head has a 10’ Travel with a Chip Box / Whip Guide. There is No Extension Table for the Work. The Drill is Currently Set-Up Using a Portion of the Stroke Capacity. There is a Work Support Carriage with a 12” 3-Jaw Chuck with 4” Thru Hole, Pressure Head, and Enerpac Hydraulic Clamping System. The Work Carrier Presently has 52” Travel on the Bedway with a Rack & Pinion Handwheel for Set-Up Positioning.

Operators Control Station with Spindle Pressure / Drill Monitor Load Meter. Spindle RPM Display. Spindle Variable Speed Controller. Feed IPM Thumb Wheel Selector. Manual and Automatic Operation Controls. Manual Operation Controls for Spindle Run. Coolant. Rapid Advance. Forward Feed, Retract, E-Stop, and Emergency Retract.

High-Pressure Coolant Filtration System with 5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it Through Filters into the Clean Coolant Top Tank. Micron Polishing Filtration with (4) Disposable Cartridge Type Filters. 10 HP Grundfos High-Pressure Coolant Pump.

Approximately (12) 60” BTA Drill Tubes with an ID Range from 1” to 2”. Tube Storage Rack. AirOil Mist Lubrication to the Spindle. Automatic Way Lubrication System. Chip Conveyor. Coolant Kooler Chiller. Manuals and Drawings. 


    Special Note: SOLD
    Comment: A Machine like this doesn't come on the market often!
    Written By: Marvin Spehar  
    *Dimensions:Available from product manager
    *Weight:Please call
    *Dimensions & Weight data are based on 3rd party information and could be incorrect; please verify & confirm if accurate dimensions & weight are required.