Last Minute Order Cancellation - 6-Day Window to Sell | Problems Viewing this Email? Click Here To ensure receipt of our e-mails, please add notifications@exfactory.net to your address book today.
Last Minute Order Cancellation! 6-Day Window to Sell - Any Reasonable Offer will be Considered
PAUL "S-1200-620" Complete 24" 5-Blade Programmable Rip System
	Year of Mfg. 2000   Elect./Voltage: 460 V, 60 Cy, 3Ph.   Appr. Repl. Cost: $ 780,000   Asking Price: $ 118,000 Make Offer!   Complete PAUL 24" 5-Blade programmable Rip System includes: Infeed Cross-Transfer, Rip Saw, and a 3-Position Marking Station. System consisting of: PAUL Model "NCD-99-907.40" Infeed Transfer with a 24" wide x 16' long 11-roller infeed with automatic 90 degree cross transfer to a 5-chain deck infeed board transfer into the Rip Saw, lumber pases under Scanner/sensors prior transfering 90 degrees into the rip saw. 16' Max. to 4' min. board length. Scanner checks for board width-and-taper and places the incoming board onto a right angle transfer/feed table, which allows the board to enter the Rip Saw "skewed" for optimum lumber utilization. Rip Saw System consists of: PAUL Model "S-1200-620" 24" width cap., double-Arbor Selective Rip Saw System. - 1st Arbor equipped with: (2) Saw hogging blades, (1) stationary and (1) programmable... (Read More)
(Owner is available to provide information on maintenance, operating hours, and production)
PAUL "MKL-11" Optimizing Cutoff System
	Year of Mfg. 2000   Elect./Voltage: 460 V, 60 Cy, 3Ph.   Appr. Repl. Cost: $ 175,000   Asking Price: $ 49,500 Make Offer!   Scanning station & optimizing Cutoff saw with slanted infeed and flat outfeed with kick-off stations. System cap. 7-7/8" width Max. Slanted infeed with right angle transfer approx. 16' long, transfer places the marked lumber accurately into the crayon scanner so that the material is feeding thru the camera. Lumber is scanned for waste, beginning-and-ending of clear zones, and for up-or-downgradable zones. The leading-and-trailing ends of the lumber are also scanned. Upon leaving the Scanner, a timing belt feeds the lumber to the optimizing Cutoff Saw. Boards are dealt to the right of the Cutoff Saw, waste is ejected out the back and collected in a waste takeaway conveyor. Cut stock is transported along the sorting belt where (1 of 9) diverters eject the cut stock from the belt and onto its take away conveyors with (7) 25" x 10' long slanted conveyors... (Read More)
Click Here to Register | Forward to a Friend Para ver en Espanol
EX-FACTORY INC. 2011 All rights reserved. Terms and Conditions You are receiving this e-mail because you provided your e-mail address to EX-FACTORY INC. or one of its partners. Please do not reply to this e-mail as it was sent from an unattended mailbox. If you wish to UNSUBSCRIBE from this newsletter, please click here. Please address questions or comments to: marthe.lapointe@exfactory.com Mail comments to: Email Compliance, 1805 Sardis Road North, Charlotte, NC 28270, USA EX-FACTORY, INC. 1805 Sardis Road North, Charlotte, NC 28270 Phone: (704) 841-2001 - Fax: (704) 841-1200 Customer Service: christiane.hallak@exfactory.com